Turn the bill over and make a 1/2-inch (1.3cm) fold in the opposite direction on the same side.More Graduation Lei Ideas. First make a 1/2-inch (1.3cm) fold across one of the short sides of the rectangular bill. The other graduate has blue and green as her school colors.2. One lei is for a graduate with red and white for the school colors. The simple origami flower for kids is ready.Graduation lei ideas Once you’re done adjusting the lei along the base ribbon, tie the ends together and add a ribbon to the joined area to hide it and decorate the lei. But if the flower is drawn upon as far as it can go, it should be well fixed at the stem without any glue. Optionally, you can fix it there with glue. Put a thin part of the stem in the hole you’ve got. The stem with a leaf is ready.Ĭut off a bottom sharp end from the tulip flower. In general, in origami, the clearer the folds the neater and more accurate is the final result. If necessary, additionally smooth all the sides or press them thoroughly. Then, pull the inner part and drag it out a bit. Now, fold this new detail in half however, this time you should join the right side with the left one. The right one.įold the long detail you’ve made in half by joining the bottom corner with the upper one. Now level the upper corners along the center. Use the same method to fold the left side of the square as well.Īgain, fold the sides using the same way by moving new corners at the center. You can use a ruler or any other flat object to do it. Smooth the fold you’ve got at the right side. Level the right side of the square along the middle fold by moving the right corner there. Open the triangle you can see a fold in the middle. You can find the sizes above.įold it in half by joining the opposite corners. Prepare a square sheet of paper that exceeds the one you have used for the flower. Making a Stem With a Leaf for Origami Tulip for Kids A half-open stem bottom easily fixes the flower at the surface. Or make an applique work: to glue the tulip flowers to construction paper, draw or glue paper stems with leaves.Įlder children can make an origami stem that will hold the tulip in a vertical position. Here are the flowers of various colours you can cut off the bottom corner to insert a tube twisted of green paper. Very small children may skip the last step. Turn it to the other side, fold the side corners a bit to make the flower look more round. Pull the right corner and position it at a small angle not reaching the angle at the top don’t level it along the fold in the middle. This step is required to find the fold only. Put a square sheet of coloured paper in front of you.įold it in half – corner to corner so that you get a triangle.įold the triangle once again by joining the angles. A green square with the 16 cm long side.A red square sheet with the 10 cm long side.In this example, common double-faced coloured paper has been used. If you have special origami paper, you should take green sheet of a larger size and a smaller red (yellow, violet, blue, etc.) sheet. Double-faced green paper for the stem with a leaf.An origami stem with a leaf is a bit more complicated, but small children can make it simpler by twisting a tube of green paper. The flower itself is extremely easy it takes only a few steps to make it. The easiest origami tulip for kids is its flat version.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |